SnagLock™

Keep the dust outlet aimed where you set it. This two-piece PETG dust-port set is designed for the Festool TS 55 REBQ and locks into a fixed position instead of rotating freely with hose movement.

The angled outlet helps route the dust hose away from the rear of the saw, while the separate three-notch locking nut secures the adapter to the compatible original Festool dust-port base. The hose-locking outlet is designed for a 36 mm Festool hose connection.

This is the 36 mm hose-locking set. The separate push-fit-only alternative is not included.

Features

• Fixed-position design helps prevent the outlet from rotating with hose movement
• Angled outlet supports cleaner hose routing behind the saw
• Two-piece locking assembly
• Three-notch press-on locking nut
• Designed for a 36 mm Festool hose connection
• PETG construction for workshop use
• No screws or additional assembly hardware required

What's Included

• 1 × PETG 36 mm Hose-Locking Dust Port Adapter
• 1 × PETG Three-Notch Locking Nut

Only the two 3D-printed PETG components are included.

Required Existing Part

• Compatible original Festool dust-port base/connector supplied with the supported saw

The printed set does not replace a missing or incompatible original saw-side dust-port base.

Not Included

• Festool track saw
• Original Festool saw-side dust-port base/connector
• Dust extractor or vacuum
• 36 mm hose or hose cuff
• Guide rail, saw blade, batteries, charger, or other saw accessories
• Wood, workbench, keyboard, tools, or demonstration props shown in photos

Material

PETG

Compatibility

Designed for:

• Festool TS 55 REBQ with the compatible original dust-port base/connector

Fit is not confirmed for Festool TS 55 EQ. Do not assume compatibility with other TS, TSC, HK, or HKC variants without comparing the saw-side dust-port interface.

Verify the complete tool model and original dust-port base before purchase.

Installation

Press the three-notch locking nut onto the adapter as shown, making sure all locking features are fully seated. Install the completed set only on the compatible original saw-side dust-port base.

Before operating the saw, confirm that the adapter, locking nut, original dust-port base, and hose connection are fully seated. Keep the hose clear of the cutting path, guide rail, moving parts, and workpiece.

Stop using the set if either printed component becomes loose, cracked, deformed, worn, or heat-damaged.

Important Note

This is a 3D-printed workshop accessory. Minor surface layer lines are normal due to the printing process and do not affect normal function.

Festool, TS 55, and REBQ are trademarks of their respective owner. Forge N Build is not affiliated with or endorsed by Festool.